Ionto Booster Solution 100ml

INDICATIONS
Concentrated salt solution that increases the water’s conductivity.
Developed for use with iontophoresis equipment.
+ Effectiveness, – Time

INGREDIENTS:
Aqua (Water), Aluminium Sesquichlorohydrate, Sodium Chloride, CI 42090
(Blue 1), Sodium Benzoate, Potassium Sorbate.

HOW TO USE:
1. Fill a container with 400 ml of cold tap water. Then pour in 10 ml of
IONTO BOOSTER SOLUTION as shown in Figure 1. The product comes with
a measuring cup that can be used to measure the required volume of the
solution.
2. Soak the lONTODRY pads well with the mixture and carefully distribute
the liquid solution among the four compartments as shown in Figure 2.
Make sure that the smaller compartments have enough liquid solution.
Always make sure not to wet the area that separates the two
compartments. This area must remain dry while using lONTODRY to ensure
the treatment is effective.
3. Once the solution has been used, clean the meter with water and close
the container with the cap. Store it correctly until its next use.

The IONTO BOOSTER SOLUTION accessory sanitary product is a solution concentrated in salts that increases water conductivity. Developed for use with iontophoresis equipment.
This product is compliant with current medical device legislation CPSP19133CAT.

Contraindications, Warnings and Precautions: This accessory is to be used in combination with iontophoresis devices. It is therefore strongly recommended to verify any contraindications, warnings or precautions associated with these devices before using the IONTO BOOSTER SOLUTION. The operation and recommended amounts of product for use with IONTODRY have been verified.
Contact the legal manufacturer for instructions on recommended use with other iontophoresis equipment. Do not use the solution undiluted. The proportions are indicated in the “How to Use” section. Do not use directly on the skin. Topical use. Keep out of reach of children. Do not use the product if the components show clear signs of contamination and/or deterioration. Do not sterilise. The product is not sterile. Do not use on open wounds. Discard the used solution after treatment with the iontophoresis device. Do not reuse.